SD2000
Get the very best from your old 2000. This was the first of Minelabs Pulse Induction detectors.
We fit the SD2000 with our custom oscillator board which enables full control over the operating frequency from 1Mhz up to 4mhz, with a switch to select from 6 frequencies. Along with this mod we also fit a fine tune control to allow interference to be tuned out easily
We fit our custom front end gain board to allow the detector to be run to the ground conditions
We also check the detector and perform any minor repairs that required
SD2100
Get the very best from your old 2100.
These detectors are good for larger, deeper gold.
We enhance this detector by enabling 3 extra timings to give you 4 timings.
We provide a frequency control with 5 positions
We fit our custom front end gain board to allow the detector to be run to the ground conditions
We also check the detector and perform any minor repairs that are required
SD2200
The SD2200 is known to be one of the deepest detectors made by Minelab.
Get the best out of your SD2200 with our set of modifications.
For the SD2200 we do:
4 timings including 3 sensitive timings
Fit a frequency control with 5 positions
Fit our custom front end gain board to allow the detector to be run to the ground conditions
Fit a genuine type 3 pin plug so you can use a handle with the ground balance button
We also check the detector and perform any minor repairs that are required