©2019 by Detectronics Australia.

SD SERIES MODIFICATIONS

Click on your detector model.

SD2000

SD2100
SD2200

 

SD2000

Get the very best from your old 2000. This was the first of Minelabs Pulse Induction detectors.

  • We fit the SD2000 with our custom oscillator board which enables full control over the operating frequency from 1Mhz up to 4mhz, with a switch to select from 6 frequencies. Along with this mod we also fit a fine tune control to allow interference to be tuned out easily

  • We fit our custom front end gain board to allow the detector to be run to the ground conditions

  • We also check the detector and perform any minor repairs that required

 

SD2100

Get the very best from your old 2100.
These detectors are good for larger, deeper gold.


  • We enhance this detector by enabling 3 extra timings to give you 4 timings.

  • We provide a frequency control with 5 positions

  • We fit our custom front end gain board to allow the detector to be run to the ground conditions

  • We also check the detector and perform any minor repairs that are required

 

SD2200

The SD2200 is known to be one of the deepest detectors made by Minelab.
Get the best out of your SD2200 with our set of modifications.

For the SD2200 we do:

  • 4 timings including 3 sensitive timings

  • Fit a frequency control with 5 positions

  • Fit our custom front end gain board to allow the detector to be run to the ground conditions

  • Fit a genuine type 3 pin plug so you can use a handle with the ground balance button

  • We also check the detector and perform any minor repairs that are required